Stakes

It's been an unpleasant job, in the wet and the wind, but we managed to finish digging the second apple-walk trench, as well as the three nursery-bed trenches. The latter came across far fewer stones, which made it easier than it could have been—we definitely picked the stoniest part of the field to build the apple walk.

Having dug the trench, we drove the first set of posts in: 2½" posts, 5'6" long, and spaced 3' apart. The first set of eleven were straightforward, but getting the second set parallel, with each one squarely opposite its pair, was a slog. Eventually, though, we got them all in, and are happy with their position. They're a bit wonky, in fairness, and not perfectly straight. I hope that we'll be able to drive the tubes for the actual arches a little more accurately. The stakes are off-set from the arches by a few inches (up-hill and outwards): the trees will be planted just outside the arch's tubes. As they're on MM106 rootstocks, they'll only need the stakes for a few years, to protect against wind rocking the roots, and then the stakes can be pulled up, or sawn off at ground level.

The nursery trenches were easier, as they don't have to be too accurate. There's a variety of heights, either 8' posts or 5'6", depending on what we intend for the adjacent tree. We can't be sure that we'll actually need them all for grafting: I've ordered three rootstocks per variety, but if the scion material is short, we may only get one, or two, scions worth from each. That's manageable: the rootstocks will 'keep'.

Once the support stakes were in, we also had posts to drive in around each set of beds (four around the nursery beds, six around the walk), which will support an anti-deer chicken-wire cage. We'll only put that up once the trees are in, to give maximum manoeuvrability for planting.